ڤولت

For other uses, see ڤولت (توضيح).

volt
Josephson voltage standard chip developed by the National Bureau of Standards as a standard volt
معلومات عامة
نظام الوحدات	SI
وحدة قياس	electric potential, electromotive force
الرمز	V
مسمى على اسم	Alessandro Volta
SI base units	kg⋅m2⋅s−3⋅A−1

The volt (symbol: V) is the unit of electric potential, electric potential difference (voltage), and electromotive force in the International System of Units (SI). It is named after the Italian physicist Alessandro Volta (1745–1827).

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 Definition

One volt is defined as the electric potential between two points of a conducting wire when an electric current of one ampere dissipates one watt of power between those points. Equivalently, it is the potential difference between two points that will impart one joule of energy per coulomb of charge that passes through it. It can be expressed in terms of SI base units (m, kg, s, and A) as

${\text{V}}={\frac {\text{potential energy}}{\text{charge}}}={\frac {\text{J}}{\text{C}}}={\frac {{\text{kg}}{\cdot }{\text{m}}^{2}{\cdot }{\text{s}}^{-2}}{{\text{A}}{\cdot }{\text{s}}}}.$

It can also be expressed as amperes times ohms (current times resistance, Ohm's law), webers per second (magnetic flux per time), watts per ampere (power per current), or joules per coulomb (energy per charge), which is also equivalent to electronvolts per elementary charge:

${\text{V}}={\text{A}}{\cdot }\Omega ={\frac {\text{Wb}}{\text{s}}}={\frac {\text{W}}{\text{A}}}={\frac {\text{J}}{\text{C}}}={\frac {\text{eV}}{e}}.$

This SI unit is named after Alessandro Volta. As with every International System of Units (SI) unit named for a person, the first letter of its symbol is upper case (V). However, when an SI unit is spelled out in English, it should always begin with a lower case letter (volt)—except in a situation where any word in that position would be capitalized, such as at the beginning of a sentence or in material using title case. Note that "degree Celsius" conforms to this rule because the "d" is lowercase.— Based on The International System of Units, section 5.2.

 Josephson junction definition

المقالة الرئيسية: Josephson voltage standard

Historically, the "conventional" volt, V₉₀, defined in 1987 by the 18th General Conference on Weights and Measures and in use from 1990 to 2019, was implemented using the Josephson effect for exact frequency-to-voltage conversion, combined with the caesium frequency standard.

For the Josephson constant, K_J = 2e/h (where e is the elementary charge and h is the Planck constant), a "conventional" value K_J-90 = 0.4835979 GHz/μV was used for the purpose of defining the volt. As a consequence of the 2019 redefinition of SI base units, as of 2019 the Josephson constant has an exact value of K_J = 483597.84841698... GHz/V, which replaced the conventional value K_J-90.

This standard is typically realized using a series-connected array of several thousand or tens of thousands of junctions, excited by microwave signals between 10 and 80 GHz (depending on the array design). Empirically, several experiments have shown that the method is independent of device design, material, measurement setup, etc., and no correction terms are required in a practical implementation.

 Water-flow analogy

In the water-flow analogy, sometimes used to explain electric circuits by comparing them with water-filled pipes, voltage (difference in electric potential) is likened to difference in water pressure, while current is proportional to the amount of water flowing. A resistor would be a reduced diameter somewhere in the piping or something akin to a radiator offering resistance to flow.

The relationship between voltage and current is defined (in ohmic devices like resistors) by Ohm's law. Ohm's Law is analogous to the Hagen–Poiseuille equation, as both are linear models relating flux and potential in their respective systems.

 Common voltages

A multimeter can be used to measure the voltage between two positions.

1.5 V C-cell batteries

The voltage produced by each electrochemical cell in a battery is determined by the chemistry of that cell (see Galvanic cell § Cell voltage). Cells can be combined in series for multiples of that voltage, or additional circuitry added to adjust the voltage to a different level. Mechanical generators can usually be constructed to any voltage in a range of feasibility.

Nominal voltages of familiar sources:

• Nerve cell resting potential: ~75 mV
• Single-cell, rechargeable NiMH or NiCd battery: 1.2 V
• Single-cell, non-rechargeable (e.g., AAA, AA, C and D cells): alkaline battery: 1.5 V; zinc–carbon battery: 1.56 V if fresh and unused
• LiFePO₄ rechargeable battery: 3.3 V
• Cobalt-based lithium polymer rechargeable battery: 3.75 V (see Comparison of commercial battery types)
• Transistor-transistor logic/CMOS (TTL) power supply: 5 V
• USB: 5 V DC
• PP3 battery: 9 V
• Automobile battery systems are 2.1 volts per cell; a "12 V" battery is 6 cells, or 12.6 V; a "24 V" battery is 12 cells, or 25.2 V. Some antique vehicles use "6 V" 3-cell batteries, or 6.3 volts.
• Household mains electricity AC: (see List of countries with mains power plugs, voltages and frequencies)
  • 100 V in Japan,
  • 120 V in North America,
  • 230 V in Europe, Asia, Africa and Australia
• Rapid transit third rail: 600–750 V (see List of railway electrification systems)
• High-speed train overhead power lines: 25 kV at 50 Hz, but see the List of railway electrification systems and 25 kV at 60 Hz for exceptions.
• High-voltage electric power transmission lines: 110 kV and up (1.15 MV is the record; the highest active voltage is 1.10 MV)
• Lightning: a maximum of around 150 MV.

 History

Alessandro Volta

Group photograph of Hermann Helmholtz, his wife (seated) and academic friends Hugo Kronecker (left), Thomas Corwin Mendenhall (right), Henry Villard (center) during the International Electrical Congress

In 1800, as the result of a professional disagreement over the galvanic response advocated by Luigi Galvani, Alessandro Volta developed the so-called voltaic pile, a forerunner of the battery, which produced a steady electric current. Volta had determined that the most effective pair of dissimilar metals to produce electricity was zinc and silver. In 1861, Latimer Clark and Sir Charles Bright coined the name "volt" for the unit of resistance. By 1873, the British Association for the Advancement of Science had defined the volt, ohm, and farad. In 1881, the International Electrical Congress, now the International Electrotechnical Commission (IEC), approved the volt as the unit for electromotive force. They made the volt equal to 10⁸ cgs units of voltage, the cgs system at the time being the customary system of units in science. They chose such a ratio because the cgs unit of voltage is inconveniently small and one volt in this definition is approximately the emf of a Daniell cell, the standard source of voltage in the telegraph systems of the day. At that time, the volt was defined as the potential difference [i.e., what is nowadays called the "voltage (difference)"] across a conductor when a current of one ampere dissipates one watt of power.

The "international volt" was defined in 1893 as 1/1.434 of the emf of a Clark cell. This definition was abandoned in 1908 in favor of a definition based on the international ohm and international ampere until the entire set of "reproducible units" was abandoned in 1948.

A redefinition of SI base units, including defining the value of the elementary charge, took effect on 20 May 2019.

 See also

• Orders of magnitude (voltage)
• Rail traction voltage
• SI electromagnetism units
• SI prefix for unit prefixes
• Standardised railway voltages
• Voltmeter

 External links

ابحث عن ڤولت في
قاموس المعرفة.

• History of the electrical units.